Vaddio CeilingVIEW 70 Manual - Manual (Page 4)

CeilingVIEW 70 PTZ – Document 010-2304-000 Rev. E
Page 4 of 14
7) The Cat.5 plenum rated cable (not included) is run from the
ceiling location where the camera is to be mounted, to where
the Quick-Connect Box is located (see Figure 5). Both the S-
Video and Composite Video outputs are active.
8) If needed, Cat.5 plenum rated cable(s) may be purchased from
Vaddio to connect your camera to a serial control daisy-chaining
between multiple cameras (see Figure 6).
9) Connections (see Figure 7):
a. Attach the installed Cat.5 cable routed from the
POWER/VIDEO jack on the back of the camera to the
Quick Connect Box.
b. If a RS-232 control cable is to be used, it should be
attached to the RS-232 IN jack (If a second or third
camera is to be used, attach a cable to the RS-232 OUT
jack and route to the next camera.
Cabling the
Camera
S-Video
Output to
Display
Device
Composite
Video
Output to
Display
Power from
PowerRite Power
Supply
Cat. 5 to/from
POWER/VIDEO
Jack on Camera
Module
Figure 5:
Quick-Connect
Box and
connections
Figure 6:
Daisy Chain Control
Connections between
cameras
(Vaddio Cameras shown,
left to right: CeilingVIEW
70 PTZ, WallVIEW 70 PTZ
and WallVIEW 50i PTZ
HideAway)
RS-232
Control IN IN IN OUT OUT
Figure 7:
RJ-45 Connections on back
of Camera Module
• POWER/VIDEO
• RS-232 IN
• RS-232 OUT (for daisy-
chain control)
Connections