Vaddio CeilingVIEW 70 Manual - Manual (Page 11)

CeilingVIEW 70 PTZ - Document 010-2304-000 Rev.E
Page 11 of 14
The RJ-45 Connector labeled RS-232 IN (see page 4) has the
following pin-outs. The DSR and DTR are added to the Vaddio
CeilingVIEW 70 PTZ and other Vaddio products to support the Sony
Daisy-chain control standard (see Figure 11).
Do not attempt to take the camera module apart (other than for the
reasons stated in the manual). There are no user-serviceable
components inside.
• Do not spill liquids onto the camera
• Keep this device away from food and liquid
• Avoid touching the lens
• For smears or smudges, clear any dust with a blower and
wipe stains with a glass cleaner and clean, soft cloth.
• To clean exterior of camera, wipe with a clean soft cloth. Do
not use any abrasive chemicals.
Do not operate the CeilingVIEW 70 PTZ under the following
conditions for any circumstance:
• Temperatures above 104°F (40°C)
• Temperatures below 32°F (0°C)
• High humidity, condensing or wet environments
• Dusty environments
• In inclement weather
• Under severe vibration
o
Storage Temperatures: -4 ˚ F (-20˚ C) to +140˚ F (60˚ C)
CARE AND
CLEANING
OPERATING
CONDITIONS
RS-232
Connection
Figure 11:
RS-232 IN pin-outs for RJ-45 connector on back of CeilingVIEW 70 PTZ