Nor-Lake AdvantEDGE Bottom Mount Refrigerators & Freezers - Manual (Page 5)

08/13 Rev. C 146527 5
To Start Rapid Freeze Mode;
• Press ‘Mode/Set’ button.
• Press ‘Up’ or ‘Down’ button until is displayed.
• Press ‘Mode/Set’ button for two seconds to start rapid freeze.
To Stop Rapid Freeze;
During rapid freeze, press ‘Mode/Set’ button for two seconds. will flash five times
and then return to normal operation.
Setting Defrost Frequency-
The unit is preset to defrost every 6 hours. The defrost frequency can be set from 4 to
12 hours with a two hour interval. During defrost is displayed instead of cabinet
temperature.
To set defrost frequency;
• Press ‘Mode/Set’ button.
• Press ‘Up’ or ‘Down’ button until
• Press ‘Mode/Set’ button to see current defrost frequency setting.
• Press ‘Up’ or ‘Down’ button until desired value is displayed.
• Press ‘Mode/Set’ button to set the value.
• Press ‘Up’ or ‘Down’ button until is displayed.
• Press ‘Verify” button to return to display cabinet temperature.
Setting Forced Defrost-
To start a forced defrost;
• Press ‘Mode/Set’ button.
• Press ‘Up’ or ‘Down’ button until is displayed.
• Press ‘Manual DF’ for 2 seconds to start a forced defrost.
To stop a forced defrost;
During a forced defrost, press ‘Manual DF’ button for 2 seconds to stop a forced defrost.
will flash five times and then return to normal operation.
TROUBLESHOOTING
Problem Possible Cause Remedy
Compressor will
not start Power connection failure Check power cord and plug it in
Power switch is in ‘off’ position Move it to ‘on’ position
The unit does
not refrigerate
well
Temperature set point is too high Correct temperature set point
The door is opened too frequently
Loading of too much warm or moist
product
Not enough ventilation
Move the unit in a well ventilated
place with at least 7 inches of
clearance on all sides
Condenser is clogged Clean it
Condensation on
cabinet exterior High humidity air can result in
condensation
Wipe with cloth