HOUNO CombiSlim C - Manual (Page 15)

C – Ver. 9.02 – June 2011 15
Error Codes
Error code 3:
Generator too hot (Generator thermoswitch has tripped. Reconnect by
pressing button under oven.)
Error code 4:
Oven too hot (Oven chamber thermoswitch has tripped. Reconnect by
pressing button under oven.)
Error code 5:
Fan too hot (Thermoswitch in motor has tripped. Wait for 10 minutes
and try again.
Error code 6:
Drain too hot (Drain temperature has been above 75°C for more than 5
min. Check that jet in drain is working.)
Error code 7:
Oven sensor defective (Temperature sensor in oven chamber not
working properly.)
Error code 8:
Core temp. probe not connected (A program using core temp. probe
has been selected but probe has not been connected.)
Error code 9:
Generator sensor defective (Temperature sensor in generator not
working.)
Error code 10:
Drain sensor defective (Sensor in drain not working. Oven can still be
used.)
Error code 11:
Water shortage (Steam generator was not filled within two minutes.
Check that the water has been turned on.)
Error code 12: SSR too hot (Solid-state relay too hot.)
Error code 13:
Generator too hot (Temperature in steam generator higher than
130°C. If fault recurs, descale generator)
Error code 14: Fan running too slow
Error code 15: Not in use
Error code 16: IO board or CPU board too hot (> 60°C)
Error code 18: Error in set-up data
Error code 19: Wrong language
Error code 20:
Internal defect (Failure in communication between computer and IO
board.)
Error code 22: Restart not possible (Oven has been without power too long.)
Error code 23: Oven too hot at CombiWash start-up
Error code 24:
Draining failure (Drain blocked or failure of drain pump. Water level in
generator still high after 10 seconds of draining.)
Error code 25:
Core temperature probe defective (1, 2 or 3 of the elements in the
core temperature probe defective.)
Error code 28: Configuration error in main alarms (3, 4, 5, 12) (warning)
Error code 29: Wrong door sensor signal (warning)
Error code 34: Water pressure too low (Check that water is turned on.)
Error code 40: Temperature in IO board critical (Warning after program run.)
Error code 43: Wrong software version (Visual Cooking I oven)
Error code 44: Failure during initialisation of exhaust at oven start-up
Error code 45: 24 V missing or failure of main contactor output