Ariens 921006 - ST1130DLE - Manual (Page 26)

GB - 26
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
DISCHARGE CHUTE (921004,
006, 007, 008, 009)
If chute does not stay in position while
throwing snow or if chute does not rotate
freely, adjust the cable under the control
panel so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the lower
adjustment nut, and then tightening the upper
adjustment nut against the bracket
(Figure 28).
If chute does not rotate freely:
Tighten the cable by loosening the upper
adjustment nut, and then tightening the lower
adjustment nut against the bracket
(Figure 29).
DISCHARGE CHUTE DEFLECTOR
(921005)
Deflector must stay in selected position while
blowing snow.
To adjust, loosen then retighten hardware to
desired deflection drag force (Figure 30).
Figure 27
2
1
1. Adjusting Nuts
2. Cable Support Bracket
OS7175
921004, 006, 007, 008, 009
Tighten upper
adjustment nut.
Loosen lower
adjustment nut.
Figure 28
OS7180
921004, 006, 007, 008, 009
Loosen upper
adjustment nut.
Tighten lower
adjustment nut.
Figure 29
OS7180
921004, 006, 007, 008, 009