Balboa Water Group Revolution - Manual (Page 70)

Revolution
Transforming the Control of Hot Tubs
70
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,
834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
Glossary (cont.)
Priming Mode
Act of water flow through the plumbing to purge air from the spa system.
Normally, priming mode can be bypassed. The priming mode is necessary only
if the spa is refilled and if there’s the possibility of air being in the system.
What Priming Mode does:
Each time the spa is powered up, it will enter Priming Mode. The purpose
of Priming Mode is to allow the user to run each pump and manually verify
that the pumps are primed (air is purged) and water is flowing. This typically
requires observing the output of each pump separately, and is generally not
possible in normal operation. Priming Mode lasts 4 minutes, but you can exit
it earlier by pressing any Temp button. The heater is not allowed to run during
Priming Mode.
NOTE: If your spa has a Circ Pump, it will turn on with Jets 1 in
Priming Mode. The Circ Pump will run by itself when Priming Mode is exited.