Balboa Water Group LM8 - Manual (Page 7)

7
MAINTENANCE SCREEN
Home > Setup > Maint
The Maintenance screen allows you to program how many
days before maintenance reminders show up.
Within the Maint screen, choose the Reminder by using the
up and down arrows, and then how many days before the
Reminder will show up. Press the Save button. When finished,
use the Back button to exit.
To select the desired water temperature of your spa, press the
Up or Down arrows. To return to the home menu, select the
Back button.
Water temperature is maintained to +/- 1 degree of the set point.
When the water reaches the set point plus one degree, the heater
will shut off. When the water drops to 1 degree below the set
point, the heater will turn back on. Whenever there is a need for
heat, the system will conduct a FLOW TEST prior to turning the
heater on. This test runs approximately 1 minute, during
which this time no pumps can be controlled from the touch
screen menu. If the test is successful, the heating pump will
turn on.
TEMPERATURE SELECTION
Home > Setup > Temperature > Select [Set Temp]
To adjust the water temperature of your spa, access the
temperature setting screen. Select the Temp button on the
home menu screen.