Balboa Water Group LM8 - Manual (Page 2)

2
INTELLECTUAL PROPERTY ADVISEMENT
All Intellectual property, as defined below, owned by or
which is otherwise the property of Balboa Water Group or
its respective suppliers relating to the Balboa Water Group
LM8 Low Maintenance System, including but not limited
to, accessories, parts, or software relating there to (the
“LM8 - Low Maintenance System”), is proprietary to Balboa
Water Group and protected under federal laws, state laws,
and international treaty provisions. Intellectual Property
includes, but is not limited to, inventions (patentable or
unpatentable), patents, trade secrets, copyrights, software,
computer programs, and related documentation, and other
works of authorship. You may not infringe or otherwise violate
the rights secured by the Intellectual Property. Moreover,
you agree that you will not (and will not attempt to) modify,
prepare derivative works of, reverse engineer, decompile,
disassemble, or otherwise attempt to create source code
from the software. No title to or ownership in the Intellectual
Property is transferred to you. All applicable rights of the
Intellectual Property shall remain with Balboa Water Group
and its suppliers.
END USER WARNING
This Installation Manual is provided solely to aid qualified spa
service technicians in installing spas with control systems
manufactured by Balboa Water Group. Balboa controls have
absolutely no end user serviceable parts. Balboa Water Group
does not authorize attempts by the spa owner/user to repair or
service any Balboa products. Non-qualified users should never
open or remove covers, as this will expose dangerous voltage
points and other dangerous risks. Please contact your dealer or
authorized repair center for service.
WARNINGS: DANGER! RISK OF ELECTRIC SHOCK!
All electrical work must be performed by a qualified UÊ
electrician and must conform to all national, state, and
local codes.
Before making any electrical connections, make certain
UÊ
that the Main Power breaker from the house breaker box
has been turned off.
Do not attempt service of this control system. Contact
UÊ
your dealer or service organization for assistance.
Do not permit any electric appliance, such as a light,
UÊ
telephone, radio, or television within 5’ (1.5m) of a pool
or spa.
Follow all owner’s manual
UÊ power connection
instructions.
Installation must be performed by a licensed electrician
UÊ
and all grounding connections must be properly
installed.
No user serviceable parts.
UÊ
Water temperature in excess of 38˚C may be injurious to UÊ
your health.
Disconnect the electrical power before servicing.
UÊ
Keep access door closed. UÊ
Important Notices
CAUTION
UÊ Test the ground fault circuit interrupter before each use
of the spa.
Read the instruction manual.
UÊ
UÊ Adequate drainage must be provided if the equipment is to
be installed in a pit.
To ensure continued protection against shock hazard,
UÊ
use only identical replacement parts when servicing.
WARNING
Water temperature in excess of 38˚C may be injurious to UÊ
your health.
Disconnect the electrical power before servicing.
UÊ
Keep the pack enclosure closed unless being serviced by UÊ
a qualified serviced technician.
GFCI COMPLIANCE
It is required by code to install a Ground Fault Circuit UÊ
Interrupter (GFCI) in the supply power for a spa. This
device will trip the breaker if there is an unsafe electrical
condition caused by a malfunctioning component or even
the slightest short to ground.
Note: Connect the control system only to a circuit
UÊ
protected by a Class A GFCI mounted at least 5’ (1.52M)
from the inside walls of the spa/hot tub and in line of sight
from the equipment compartment.
Refer to
UÊ NEC (National Electrical Code), 2005 Edition,
Article 680 for more information.
©2012 Balboa Water Group. All rights reserved.