AeroBed Overnighter - Manual

IMPORTANT SAFETY INFORMATION AND WARNINGS
7960 Rev 1/08
HB138 - 4D Battery Pump
Instruction Manual
Thank you for joining the AeroBed ® family by purchasing one of our upscale products. You can expect top-notch quality, innovation, and imagination from every
AeroBed product. You are about to enjoy the comfort of an AeroBed product. It is your responsibility to read and always follow the safety, care, and maintenance
instructions for your new AeroBed. Always instruct and supervise others on your product’s proper use, maintenance, and safety.
IMPORTANT: Preparation of your product requires no tools. Use of tools may damage your product.
WARNING: Adult supervision required for inflation, deflation, and maintenance. This is not a lifesaving device.
WARNING: This bed is not designed for use by children under 3 years of age or persons with limited mobility. Children under the age of 3 or persons with limited
mobility may suffer serious or fatal injury through suffocation, falling from the bed or becoming trapped between the bed and a wall or other objects.
WARNING: This furnishing has not been evaluated for flammability or cigarette ignition resistance.
- This is not a water toy. Use as a mattress only.
- Place bed in a safe area before use, making sure that there are no sharp edges, steps, drops, or breakable items nearby. Use on flat surfaces only. Bed may tip
over on uneven surfaces.
- Do not use this bed on abrasive surfaces or near pointed/sharp items or surfaces. Protruding objects may puncture bed. Remove all sharp objects from area
where bed will be set up and used.
- Do not step or jump on product or use as a trampoline. Product may puncture.
- Standing, jumping, or walking on the product may result in injury and/or damage the product. Do not jump, stand, or walk on this product. You can hurt yourself or
damage the product if you do.
- This product is made of plastic and therefore may melt or burn if it comes in contact with any flame or heat source. Do not place it near or against heaters, open
flame, or other hot objects.
WARNING: This is an electrical product - not a toy. To avoid risk of fire, burns, injury, or shock, it should not be played with or placed where small children can
reach it.
WARNING: Product is for indoor use only.
WARNING: For household / residential use only.
- Pump is an electrical device. Do not use in or around water.
- Turn off pump when not in use.
- DO NOT place pump where it could fall or be pulled into the water.
- Pump not recommended for use by children under six (6) years of age.
- It is recommended to separate batteries from case when pump is not in use.
- Do NOT mix old and new batteries. Do not mix alkaline batteries (NOT INCLUDED). Make certain the batteries are installed correctly.
- Do not attempt to disassemble, repair, or service the pump. No serviceable parts are contained inside. Contact
Aero Products International, Inc. at 1834 Walden Office Square, Third Floor, Schaumburg, IL 60173, for repair or servicing
information.
PRODUCT/PUMP
INFLATION
Note: Product must be at room temperature prior to inflating or it may cause air leaks.
1. Place your rolled up product on the floor or other surface free of obstructions or sharp objects.
2. Remove pump from protective plastic shipping wraps.
3. Remove battery cover; insert four new D-cell Alkaline batteries (NOT INCLUDED). Make certain the batteries are installed correctly.
4. Replace battery cover, click sides to lock cover.
5. Open protective cap on valve. Press mouth of pump into position and turn pump to “on” position.
6. In approximately 60 seconds, your bed will be inflated to the firmest capacity. Turn pump to “off” position.
7. Detach pump, lie on bed and check the firmness. For a softer bed, press the valve to release air. If the bed becomes too soft, re-attach
the pump and reinflate the bed until the desired level of firmness is achieved. Replace valve cap.
CARE AND MAINTENANCE
1. Inspect your AeroBed prior to each use.
2. Keep your AeroBed away from any sharp objects. Large cuts or snags may not be repairable and will not be covered by your warranty.
3. When not in use, store you AeroBed in a clean, dry place out of extreme temperatures. Product must be at room temperature prior to
inflating.
4. Do not store your AeroBed folded inside sofa beds or roll-aways. This may cause damage to your bed that will not be covered under your
warranty.
5. In case of incidental damage to your bed, a repair patch has been included. Please follow repair instructions carefully.
DEFLATION AND STORAGE
1. Open protective cap on valve. Locate deflate port on top of pump.
2. Press deflate port into mouth of valve and then turn pump to “on” position.
3. Your bed will begin to deflate, once deflated, turn pump to “off” position.
4. Roll the bed towards the valve until all the air is expelled. When the bed is completely rolled, replace the valve cover.
5. Slide the storage bag over your bed. Store your bed and pump until its next use.
NOTE: Store your AeroBed in a clean dry place at room temperature (above 50° F/10° C). Storing your AeroBed under 50° F (10° C) and
over 100° F (38° C) may affect its performance and will not be covered under your warranty.
BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY.
Open Valve
Pump
Inflation
Port
Deflation
Port