Panasonic BL-MS103A - Manual (Page 134)

11 Changing the Camera's User Name
134
11 Changing the Camera's User Name
To view images from cameras registered using Quick Setup on a computer without
setting the administrator name or password, change the user name and password
for a camera using the following procedure.
1. Select [General Setup] from the [Setup] screen (see page 95) and press
[ENTER].
2. Set the administrator name and password on the [Camera] tab (see
page 100).
3. Move the mode switch on the BL-WV10A to Setup and turn the power on
again.
4. Reset the camera to its default settings and re-perform Quick Setup as when
adding more cameras (see page 132).
• To see a camera image on a computer, launch a web browser on the
computer and access the camera.
• The user name and password for the camera are the same as the
administrator name and password set in step 2 above.
Note
• When Quick Setup begins, the Quick Setup screen for the camera in
question will change from [Complete] to [Setting]. When registration is
complete, [Finished] will be displayed.
• The administrator name and password must be between 6 and 15
alphanumeric characters in length. The following characters cannot be
used: " < > : &.