Airlink101 AR570W - Manual (Page 31)

32
¾ LAN IP section
Parameters Default Description
IP address 192.168.2.1 This is the router’s LAN IP address (Your LAN clients’
default gateway IP address).
Subnet Mask 255.255.255.0 Specify a Subnet Mask for your LAN segment.
802.1d Spanning Tree Disable If you wish to activate 802.1d spanning tree function,
select “Enabled”, or set it to “Disabled”
If 802.1d Spanning Tree function is enabled, this router
will use the spanning tree protocol to prevent from
network loop happened in the LAN ports.
DHCP Server Enable By enablting the DHCP server, the router will
automatically give your LAN clients an IP address. If the
DHCP server is not enabled then you’ll have to manually
set your LAN client’s IP addresses; make sure the LAN
Client is in the same subnet as this broadband router if
you want the router to be your LAN client’s default
gateway.