Airlink101 AWLL3028 - Manual

Rev. 1.2
Package Content:
•
Wireless USB 2.0 Adapter
• USB Cable
• Driver & Utility CD
• Quick Installation Guide
Section 1
Install Utility Software
Quick Installation Guide
This Quick Installation Guide only provides basic instructions. For more advanced
features such as configuring encryption settings, please refer to the User’s
Manual on the provided CD.
Note: Be sure to power off your computer before inserting the USB adapter.
Insert the USB adapter into an available USB port and turn on your
computer.
Windows 2000/XP Users: After turning on the computer, Windows will launch the
Found New Hardware Wizard. The Found New Hardware Wizard appears
differently depending on your operating system. Click Cancel to quit the wizard
and insert the Installation CD into your CD drive Skip ahead to Step 1.
Note: If the Autorun screen doesn’t appear automatically go to Start, Run, and
type D:\Utility\Setup.exe (where D is the letter of your CD drive) and click OK.
Model # AWLL3028
802.11g Wireless USB 2.0 Adapter
Windows Vista Users: After turning on the computer, Windows will install its built
in driver for this card. A popup window will appear telling you that the driver was
installed correctly.
Step 1 The Autorun screen will pop up. Select Install Driver and Utility from the
menu.
Windows Vista Users: At this point, you may get a warning message like the one
below. Make sure that you click “Allow” to continue with the installation.
Once you see this message, insert the installation CD and continue to Step 1.