Asus WL-330 - Manual (Page 70)

5-2 ASUS Pocket Wireless Access Point (WL-330)
Troubleshooting
Problem Action
The ASUS Pocket Wireless AP
does not power up. • Use a test meter to measure the
voltage output of the power source
through the power plug.
• Check if the power plug is properly
connected to the device.
This troubleshooting guide provides solutions to some common problems that
you may encounter while installing and/or using ASUS Pocket Wireless AP.
These problems require simple troubleshooting that you can perform by
yourself. Contact the ASUS Technical Support if you encounter problems not
mentioned in this section.
Other devices cannot
communicate with the ASUS
Pocket Wireless AP through a
wired network connection. • Verify your network configuration to
ensure that there is no IP address
duplication. Turn off the device in
question, then ping the assigned IP
address of the device. Make sure
no other device responds to that
address.
• Check if the cables have the proper
pin outs and connectors. You may
also use another LAN cable.
• Make sure the hub, switch, or
computer connected to the ASUS
Pocket Wireless AP supports
10Mbps speed.
Do this by check the ASUS Pocket
Wireless AP and the Hub LEDs.
When you connect the ASUS
Pocket Wireless AP to a 10/100
Mbps hub, both the Hub LED and
the ASUS Pocket Wireless AP
Ethernet LEDs should light up.