Avaya 16-300310 - Manual (Page 17)

Configure H.323 video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup For feedback, use [email protected] August 2010 17
Configuring Polycom RMX Series Video Conferencing Bridge
Platform
Use this procedure to configure the Polycom RMX series video conferencing Bridge platform.
Table 8: Configuring Polycom RMX Series Video conferencing on Bridge Platform
1. Enter change node-names ip to add an entry for the RMX system. Be sure to enter
the IP address of the IP board for the RMX system.
2 Enter add trunk-group to add a two-way trunk group for the RMX system. Set the
following parameters:
●
Group Type: ISDN
●
Direction: Two-way
●
Carrier Medium: H.323
●
Service Type: Tie
3 Enter add signaling-group to add a signaling group for the RMX system. Set the
following parameters:
●
Group Type: H.323
●
IP Video: y
●
Priority Video. If you want all incoming calls to receive priority video
transmissions: y
●
Trunk Group for Channel Selection to the two-way trunk group you added.
●
Near-end Node Name. PROCR may be used for all systems and CLAN may be
used for systems with port networks.
●
Near-end Listen Port: 1720
●
LRQ Required: n
●
RRQ Required: y
●
Enable Layer 3 Test: n
●
Far-end Node Name to the name you entered for the RMX system
●
Far-end Listen Port: 1720
●
Far-end Network Region
●
Calls Share IP Signaling Connection: n
●
Direct IP-IP Audio Connections: y
●
IP Audio Hairpinning: n