American Dryer Corp. AD/ML-310 - Manual (Page 38)

38 American Dryer Corp. 113217 - 5
b. Steam Models
1) Check to ensure that the steam damper is functioning properly.
2) Make a complete operational check of ALL safety-related circuits (i.e., lint drawer switch and sail switches
on gas models).
3) Reversing basket (tumbler) dryers should never be operated with less than a 204 lb (92.53 kg) load (dry
weight), since the load’s weight affects basket (tumbler) coast time during a direction reversal command. It
is important that the basket (tumbler) come to a complete stop prior to starting in opposite direction. For
automatic (mode) cycle only, the spin and stop times are not adjustable and have been preprogrammed into
the microprocessor controller (computer) for a 2-1/2 minute reverse spin time and a 7-second dwell (stop)
time.
BASKET (TUMBLER) COATING
The basket (tumbler) is treated with a protective coating. We suggest dampening old garments or cloth material with a
solution of water and nonflammable mild detergent and tumbling them in the basket (tumbler) to remove this coating.
4) Each dryer should be operated through one (1) complete cycle to ensure that no further adjustments are
necessary and that ALL components are functioning properly.
5) Microprocessor controller (computer) programs/selections – each microprocessor controller (computer)
has been preprogrammed by the factory with the most commonly used parameter (programs) selections. If
computer program changes are required, refer to the Computer Programming Manual, which was shipped
with the dryer.
J. PREPARATION FOR OPERATION/START-UP
The following items should be checked before attempting to operate the dryer:
1. Read ALL “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data label.
3. GAS MODELS – Check to ensure that the dryer is connected to the type of heat/gas indicated on the dryer data
label.
4. GAS MODELS – The sail switch damper assembly was installed and adjusted at the factory prior to shipping.
However, each sail switch adjustment must be checked to ensure that this important safety control is functioning.
5. GAS MODELS – Be sure that ALL gas shutoff valves are in the open position.
6. Be sure ALL side and base panels are on the dryer.
7. Check ALL service doors to ensure that they are closed and secure.
8. Be sure lint drawer is securely in place.
NOTE: LINT DRAWER MUST BE ALL THE WAY IN PLACE TO ACTIVATE SAFETY
SWITCH, OTHERWISE THE DRYER WILL NOT START.