American Standard SPEED CONNECT 4508.4 User Manual

Page 4

M968845 Rev. 1.2

INSTALL HANDLES

CHECK DRAIN CONNECTIONS

TEST INSTALLED FITTING

With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.

Operate both HANDLES (1) to flush water
lines thoroughly.

Rotate TRANSFER VALVE (5) from rim wash to
spray several times to check operation.

Pull up POP-UP KNOB (3) and fill Bidet with water. Check
that DRAIN STOPPER (4) makes a good seal and retains
water in Bidet. If STOPPER (4) does not seal properly,
please refer to “Troubleshooting Guide” in these instructions.

Push POP-UP KNOB (3) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.

SPRAY

OUTLINE OF BIDET

TOP

Figure "A"

SPLINE END DOWN

Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. See figure "A". Tighten
STEM SCREW (3) to secure ADAPTER (1).

Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting
male teeth on ADAPTER (1) to female teeth in HANDLE (4).

Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5)
until snug against mounting surface

THREAD ON

TO DECK

ADAPTER

SERVICE

90˚

To change direction of handle rotation,

proceed as follows:

Turn valve to OFF position. Unthread HANDLE

BASE (1) from DECK ADAPTER (2).

Pull HANDLE ASSEMBLY off VALVE STEM (3).

Remove SPRING CLIP (4). Lift STOP WASHER (5),

turn 90˚ and replace. Replace SPRING CLIP (4).

Find correct position of HANDLE ASSEMBLY by adjusting

male teeth on VALVE STEM (3) to female teeth in HANDLE.

Thread HANDLE ASSEMBLY onto DECK ADAPTER (2)

until snug against mounting surface.

If spout drips, operate handles several times from

OFF to ON position. Do not force - handles turn

only 90˚ .

UNTHREAD

HANDLE

ASSEMBLY

DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER.DRY
WITH A SOFT COTTON FLANNEL
CLOTH.

DO NOT: DO NOT CLEAN THE
PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.

CARE INSTRUCTIONS: