American Standard QUINCE 4433.001 - Manual

SINGLE CONTROL KITCHEN
FAUCET WITH CAST SPOUT
Installation
Instructions
Certified to comply with ANSI A112.18.1M
4433.001
1
9
3
A B
CAUTION
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON Turn off hot and cold water
supplies before beginning.
PUTTY
SINK OR
MOUNTING
SURFACE
Plumbers' Putty or Caulking
Adjustable Wrench Phillips Screwdriver
Recommended tools
Regular Screwdriver
2
M 9 6 5 115 _ Rev. 1. 3
QUINCE™
Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (6) and check that rotation of HANDLE (7) from HOT to COLD
is centered.
Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening
the screws slightly each time until all are snug to ensure even pressure.
Make certain the SEAL (9) is properly seated in recess of spout base.
(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1).
Insert supply HOSES (2) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and mounting surface.
Follow mounting instructions below to secure faucet to mounting surface.
(B) Installation less ESCUTCHEON (1). Insert all HOSES (2) and SHANK (3) through MOUNTING RING (10) and
mounting surface. Do not use putty.
4
5
6
8
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
7
4
5
6
8
7
9
10
3
2