Autostart CT-5460TW - Manual (Page 5)

User Guide P. 5
To enable Idle Mode:
1. With the engine running, press the
LOCK or UNLOCK button (to unlock the doors) or the
START/STOP button on the remote control until the parking lights come on.
2. Remove the key and exit the vehicle. The engine will go on running.
3. Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time .
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Turbo Mode
If turbo mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine and set the system to ready mode.
To activate turbo mode, follow all steps of the ready mode routine:
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. press
LOCK , UNLOCK or START/STOP on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a. LOCK to lock the doors and shut down the engine after 60 sec.;
b. UNLOCK to unlock the doors and shut down the engine after 60 sec.;
c. START/STOP to shut down the engine immediately, without affecting the doors
(This will by-pass turbo mode).
Valet Mode with the Valet Switch
The system can be placed in Valet Mode to disable the remote starting capabilities. If the vehicle
needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being
accidentally started by remote control.
To put the system i n t o Valet Mode:
1. Turn the ignition key to the
IGNITION ON (RUN) position.
2. Within 3 sec., press the valet button (the L.E.D. will come ON solid).
To take the system o u t o f Valet Mode:
1. Turn the ignition key to the
IGNITION ON (RUN) position.
2. Within 3 sec., press and release the valet button (the L.E.D. will come OUT ).
Note: Once Valet Mode is activated, the remote starter and alarm functions will be disabled.
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the vehicle
needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being
accidentally started by remote control.
To ENTER Valet Mode
1. With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION) and then OFF positions 5
times within 10 seconds.
2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode. The LED will
turn ON solid.
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode. The LED will
turn OFF.