Autostart CT-5460TW - Manual (Page 11)

User Guide P. 11
Your installer can customize the system as to personalize these multi-level features in an order that
best suits you. Your options are:
Option 1:
Level 1 (requires pressing the FUNCTION button 1X) Æ Multi car operation
Level 2 (requires pressing the FUNCTION button 2X) Æ Basic features
Level 3 (requires pressing the FUNCTION button 3X) Æ Customized features
Option 2:
Level 1 (requires pressing the FUNCTION button 1X) Æ Basic features
Level 2 (requires pressing the FUNCTION button 2X) Æ Multi car operation
Level 3 (requires pressing the FUNCTION button 3X) Æ Customized features
Option 3:
Level 1 (requires pressing the FUNCTION button 1X) Æ Customized features
Level 2 (requires pressing the FUNCTION button 2X) Æ Multi car operation
Level 3 (requires pressing the FUNCTION button 3X) Æ Basic features
Option 4:
Level 1 (requires pressing the FUNCTION button 1X) Æ Basic features
Level 2 (requires pressing the FUNCTION button 2X) Æ Customized features
Level 3 ( requires pressing the FUNCTION button 3X) Æ Multi car operation
Example: If the multi-level features were set to option 3, the setup would be as follows:
x Level 1 Æ Customized feature
x Level 2 Æ Multi car operation
x Level 3 Æ Basic
features
The “Basic features” are now programmed as level 3 and therefore:
x To access the aux. 2 feature, the user needs to press on the
FUNCTION button three (3) times
followed by the LOCK button.
x To access cold weather mode, the user needs to press on the FUNCTION button three (3) times
followed by the START/STOP button .
L.E.D. Intrusion Codes
If an intrusion took place while your vehicle was locked and the system was armed, the L.E.D. will
provide feedback on the intrusion. The L.E.D. intrusion codes are flashed by the L.E.D. in
continuous loops and are as follows:
1 flash = power-up reset: battery
disconnected and reconnected,
or dead battery.
2 flash = doors intrusion
3 flash = shock sense
4 flash = hood
5 flash = panic
6 flash = ignition
Troubleshooting Poor Transmitting Range
x Many factors may affect the operating range of the transmitter. Some of these are:
x The condition of the battery in the transmitter.
x The operating environment (for example: downtown radio-frequency noise, airports, cellular
phone towers…)
x Metal: any type of metal will affect operating range. This includes the metal in the car.
x The shape of the vehicle can affect range as well; vans in general have an especially poor
range.
x The shape of the roof and A-pillars brings about considerable radio-frequency deflection (in this
case the signal from the remote control). As a result, the direction in which the vehicle is facing
in relation to the remote control can affect the range. Straight on – standing in front of the
vehicle – generally gives you the greatest range; the second best performance is from the back.
Using the remote control from either side of the vehicle will usually give the lowest range.
x The range will be significantly lower in a crowded parking lot than in open space.
x Always hold the transmitter high, approximately at shoulder height. Holding the transmitter
against your chin will also increase your range: your head acts as an antenna.
x The operating range will be somewhat lower on vehicles equipped with an aftermarket or factory
alarm.