Sony ICD-MS1 - Manual (Page 13)

13
Basic Operations
To stop recording
You can also stop recording by pressing the
STOP button instead of the zREC/STOP
button.
To change the recording mode
See page 34.
To select the microphone
sensitivity
You can select the microphone sensitivity by
switching the MIC SENS selector on the rear
of the unit.
H (high): To record at meetings or in a quiet
and/or spacious place.
L (low): To record dictation or in a noisy
place.
Recording with an external
microphone or from other
equipment
See page 37.
Other operations
To listen to the current recording
Press zREC/STOP button or STOP button to
stop recording, then press the jog lever.
To review the current recording
instantly
Press the jog lever during recording.
To monitor the recording
Connect an earphone or headphones (not
supplied) to the v (earphone) jack.
You can adjust the volume with the VOL
control, but the recording level is fixed.
Note
If you turn up the volume excessively or place the
earphone near the microphone while monitoring the
recording, the microphone may pick up the sound
from the earphone, causing acoustic feedback
(howling sound).
To pause recording
To Do this
pause recording* Press X(pause)
button. During
recording pause, the
OPR indicator flashes
in red and “PAUSE”
flashes in the display
window.
release pause and Press X(pause)
resume recording button or zREC/
STOP button.
Recording resumes
from that point.
(To stop recording
after pausing
recording, press
STOP button.)
* About one hour after you pause recording,
recording pause is automatically released and the
unit goes into the stop mode.
Continued