Sony HDR-SR1 - Manual (Page 104)

104
Troubleshooting (Continued)
You cannot dub correctly using the HDMI cable.
• You cannot dub images using the HDMI cable.
You cannot dub correctly using the A/V connecting cable.
• The A/V connecting cable is not connected properly. Make sure that the A/V connecting
cable is connected to the proper jack, i.e. to the input jack of another device for dubbing a
image from your camcorder (p. 62).
Prints cannot be made using a PictBridge printer.
• Your printer may not print images edited on a computer or recorded using other devices. This
is not a malfunction.
Unable to clip a still image from a movie on the hard disk of your camcorder.
• You cannot clip a still image from a movie stored on your camcorder.
The beep sounds for 5 seconds.
• The temperature of your camcorder is extremely high. Turn off your camcorder and leave it
for a while in a cool place.
• Some problems have occurred in your camcorder. Turn off, and on, then operate your
camcorder again.
• The temperature of your camcorder is extremely low. With POWER switch turned on, leave
the camcorder for a while. If you still cannot operate the camcorder, turn it off, taking it to a
warm place. Leave the camcorder there for a while, then turn on the camcorder.
A computer does not recognize your camcorder.
• Install Picture Motion Browser (p. 91).
• When you connect your camcorder to a computer for the first time, it may take some time for
the computer to recognize the camcorder. Wait for a while.
• Disconnect the USB device other than the keyboard, the mouse, and the camcorder from the
computer.
• Disconnect the cable from the computer and camcorder, restart the computer, then connect
them again correctly.
Cannot use the supplied software, Picture Motion Browser, on the Macintosh
computer.
• You cannot use Picture Motion Browser on a Macintosh.
Others
Connecting to a computer