Sony MZ-N1 - Manual (Page 81)

81
No sound comes
through the
headphones/
earphones. • The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i
/LINE OUT.
• The plug is dirty.
, Clean the plug.
• The “AUDIO OUT” parameter for the i/LINE OUT jack is set to
“LINE OUT”.
, Set to “HeadPhone”.
Volume cannot be
turned up. • AVLS is on.
, Release AVLS settings (page 70).
An MD is not
played normally. • Playback mode is changed.
, Use the jog dial on the recorder or press RPT/ENT on the
remote control to change back to the normal play.
An MD is not
played from the
first track. • Disc playing stopped before it came to the last track.
, Press N for 2 seconds or more to start playing, or press the
control towards . repeatedly on the remote.
• Group mode is turned on.
, Turn group mode off and play from the first track (press N for
2 seconds or more to start playing, or press the control towards
. repeatedly on the remote).
• The disc information has been stored to the Personal Disc Memory.
, Erase the disc information from the Personal Disc Memory.
Playback sound
skips. • The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a track under one second long.
Sound has a lot of
static. • Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
The rechargeable
battery does not
start charging.
The rechargeable
battery cannot be
fully charged. • The rechargeable battery has been inserted incorrectly or the AC
power adaptor has been connected incorrectly.
, Insert the battery correctly or connect the AC power adaptor
correctly.
• The terminals of the battery charging stand is dirty.
, Clean the terminals with a dry cloth (page 76).
The clock loses
time or the
display flashes.
The recording
date was not
stamped onto the
disc. • The built-in battery for the clock is weak.
, Connect the AC power adaptor to DC IN 3V on the recorder and
the wall outlet to charge the built-in battery. After charging, set
the clock again (page 38). Note that the clock may gain or lose
up to about 2 minutes per month under normal condition.
• The clock is not set.
, Set the clock (page 38).
Symptom Cause/Solution