Sony STR-DA2800ES - Manual (Page 88)

88 US
To set up speakers
For details, see “Speaker Connection” in the
Speaker Settings menu (page 93).
Notes
• Make the bi-amplifier settings before you perform
the Auto Calibration function.
• If you make the bi-amplifier settings, the speaker
level, balance, and equalizer settings of the
surround back speakers and front high speakers
become invalid, and those of the front speakers are
used.
• If the speaker pattern is set so that there are
surround back speakers and front high speakers,
you cannot set the SURROUND BACK/FRONT
HIGH/FRONT B/ZONE 2 terminals for a bi-
amplifier connection.
• When you operate the receiver without using the
GUI, set “SB ASSIGN” to “BI-AMP” in
“SPEAKER” (page 113).
Reverting back to the
factory default settings
You can clear all memorized settings and
revert the receiver back to the factory default
settings by performing the following
procedure. This procedure can also be used to
initialize the receiver before you use it for the
first time.
1
Press ?/1 to turn off the
receiver.
2
While holding down the TONE
MODE and 2CH/A.DIRECT,
press ?/1 to turn on the
receiver.
3
Release the TONE MODE and
2CH/A.DIRECT after a few
seconds.
The “CLEARING...” appears on the
display window for a while, then changes
to “CLEARED!”
Changes or adjustments made to the
settings are now reset to the defaults.
Note
It takes about a few minutes for the memory to be
cleared completely. Do not turn the receiver off until
“CLEARED!” appears on the display.
?/1
TONE MODE
2CH/A.DIRECT