Sony ILCE-7S - Manual (Page 173)

RMT-DSLR1 Wireless Remote Commander (sold separately) and RMT-DSLR2 (sold
separately). Refer also to the operating instructions for the Wireless Remote Commander.
1. MENU
→ (Setup) → [Remote Ctrl] → desired setting.
Menu item details
On:
Allows Wireless Remote Commander operation.
Off (default setting):
Does not allow Wireless Remote Commander operation.
Note
The RMT-DSLR1 Wireless Remote Commander cannot be used for movie recording.
The lens or lens hood may block the remote sensor that receive the signals. Use the
Wireless Remote Commander in the position from which the signal can reach the product.
When [Remote Ctrl] is set to [On], the product does not switch to power save mode. Set
[Remote Ctrl] to [Off] after using a Wireless Remote Commander.
[200] How to Use Changing settings Setup menu
HDMI Resolution
When you connect the product to a High Definition (HD) TV with HDMI terminals using an
HDMI cable (sold separately), you can select HDMI Resolution to output images to the TV.
1. MENU
→
(Setup
) → [HDMI Settings] → [HDMI Resolution] → desired setting.
Menu item details
Auto (default setting):
The product automatically recognizes an HD TV and sets the output resolution.
1080p:
Outputs signals in HD picture quality (1080p).
1080i:
Outputs signals in HD picture quality (1080i).
Note
If the images are not displayed properly using the [Auto] setting, select either [1080i] or
[1080p], based on which TV is to be connected.