Sony SVR-2000 - Manual (Page 49)

49 Guided Setup
filename[04 setup fm] model name1[PTV Receiver]
Se
tting
Up Y
our
Sy
ste
m
IR Picking List. This screen presents a list of IR codes superimposed over Live
TV. Each code has a fast, medium, and slow choice. First, find a code that works,
then try the different speeds for that code. Use the fastest speed that changes the
channels correctly every time. Use the UP/DOWN arrows to move the highlight
bar down the list of codes. For each code, press the CH (channel) +/– buttons
10–15 times. Pay close attention to how well the code you’re testing changes
channels. When you find the code that works best, press SELECT to choose that
code.
Program Call. The last step of Guided Setup is to make a second call to get the
program guide listings. Press SELECT to start the call, which will use the telephone for
about 10-20 minutes. During this call, the TiVo Service downloads all your program
guide information for the next two weeks. Immediately following the call, the SVR
Recorder spends 1–2 hours sorting and indexing the data so that it can be searched. The
more channels you receive, the longer it takes to sort the information.
If you need to use the phone during the program call, simply pick up the telephone and
the SVR Recorder will hang up. You will then need to repeat the program call when
you are done using the phone line.
If the Recorder repeatedly reports a busy signal trying to connect, try choosing a
different local dial-in number, or try making the call during off-peak hours.
Congratulations! When the SVR Recorder has finished importing and indexing your
program guide information, it will beep three times. Press SELECT to continue, and
you’ll see the Congratulations! screen shown at left.
01_COV.book Page 49 Sunday, May 26, 2002 11:46 AM