Sony DSC-W100 - Manual (Page 83)

83
Tr
oub
lesh
oo
ti
n
g
The battery pack cannot be installed.
• As you insert the battery pack, use the tip of the battery pack to push the battery eject lever
toward the lens (
t step 1 in “Read This First”).
• Install the battery pack correctly ( t step 1 in “Read This First”).
The battery remaining indicator is incorrect, or sufficient battery remaining
indicator is displayed but the power runs out too quickly.
• This phenomenon occurs when you use the camera in an extremely hot or cold location
(page 99).
• The displayed battery remaining differs from the current one. Fully discharge and then charge
the battery pack to correct the display.
• The battery pack is discharged. Install the charged battery pack ( t step 1 in “Read This
First”).
• The battery pack is dead (page 99). Replace it with a new one.
The battery pack runs down too quickly.
• Charge it sufficiently ( t step 1 in “Read This First”).
• You are using the camera in an extremely cold location (page 99).
• The battery terminal is dirty. Clean the battery terminal with a cotton swab, etc., and charge
the battery pack.
• The battery pack is dead (page 99). Replace it with a new one.
Cannot turn on the camera.
• Install the battery pack correctly ( t step 1 in “Read This First”).
• The battery pack is discharged. Install charged battery pack ( t step 1 in “Read This First”).
• The battery pack is dead (page 99). Replace it with a new one.
The power turns off suddenly.
• If you do not operate the camera for about three minutes while the power is on, the camera
turns off automatically to prevent wearing down the battery pack. Turn on the camera again
(
t step 2 in “Read This First”).
• The battery pack is discharged. Install charged battery pack ( t step 1 in “Read This First”).
Battery pack and power