Reconfiguring deployed network management cards, Reconfiguring deployed network management, Cards – American Power Conversion AIRACPA4000 User Manual

Page 9: Addendum, Networka ir acpa4000

ADDENDUM

NetworkA

IR ACPA4000

Reconfiguring deployed Network Management
Cards

1. Use the link in the

Start

menu to launch the Wizard application, and

then click

Next >

on the opening screen.

2. Select the

Custom (Advanced)

option from the “Installation Options”

screen, and then click

Next >

3. Select the

Define a New Configuration File (Typical)

option from the

“Custom Installation” screen, and then click

Next >

4. Click

Next >

as many times as needed to cycle through the Network

Management Card’s settings. Bypass any setting that you do not want
to configure.

5. Stop at the “Customize the settings that will be transmitted to the

Management Card” screen, and choose the settings to transmit to the
Network Management Cards. (Choose only settings that are generic
across multiple Network Management Cards.) Then click

Next >

To perform this procedure, the FTP server must be enabled.

Because the Wizard uses FTP to reconfigure Network
Management Cards, do not disable

FTP Server Access

Deselect the

TCP/IP

settings (

System IP

Subnet Mask

Default Gateway

addresses, and

BOOTP

) and

FTP Server

Access

settings so that they will not overwrite these

settings when you transfer the new settings.