Addendum, Networka ir acpa4000 – American Power Conversion AIRACPA4000 User Manual
Page 17
®
®
®
®
ADDENDUM
NetworkA
IR ACPA4000
16
2. Open an FTP client session:
C:\apc>
ftp
3. Type
open
and the Network Management Card’s IP address, and
press
E
NTER
. If the
Port
setting for
FTP Server
in the
Network
menu
has changed from its default value of
21
, you must use the non-default
value in the FTP command.
a. For some FTP clients, use a colon to add the port number to the end
of the IP address.
You cannot upgrade the AOS firmware module of any APC
device directly from firmware version 1.x.x to 2.1.0 or later.
The upgrade attempt will fail.
To upgrade the AOS firmware module of an APC device from
version 1.x.x to 2.1.0, use the firmware upgrade tool, a self-
extracting executable file available on the NetworkAIR PA
Utility CD or available at no cost from the support section of
the APC web site (
).
Each upgrade tool is specific to an APC product type. Do not
use the tool from one product CD to upgrade firmware of a
different APC product. If you use a version of the tool from
the APC Web site, make sure that you use the upgrade tool
that corresponds with your APC product type.
If your APC device is running version 2.0.1 or later of the
AOS firmware module already, you may upgrade directly to a
later 2.x.x version 2.1.0 or a later version.