American Power Conversion AIRACPA4000 - Manual (Page 16)

® ® ® ®
ADDENDUM
NetworkA
IR ACPA4000
15
Use FTP or SCP to upgrade one Network
Management Card
For you to be able to use FTP to upgrade a single Network Management
Card over the network:
• The Network Management Card must be connected to the network.
• The FTP server must be enabled at the Network Management Card.
• The Network Management Card must have its TCP/IP settings
( System IP , Subnet Mask , and Default Gateway addresses)
configured.
To use FTP to upgrade the Network Management Card:
1. Open an MS-DOS command prompt window on a computer that is
connected to the network. Go to the directory that contains the
firmware upgrade files, and list the files. (For the directory
C:\apc , the
commands would be those shown in bold ):
C:\> cd\apc
C:\apc> dir
Files listed for a Network Management Card, for example, might be the
following:
– apc_hw02_aos_228.bin
– apc_hw02_nairpa_106.bin