Easy setup advanced setup – Sony LF-PK1 User Manual
Page 54
Oth
e
rs
54
Easy Setup
Advanced Setup
Problem
Causes and remedies
NETWORK LED of the base station
does not light up.
Check the “Cannot connect to the Internet” (
Station.”
NETAV LED of the base station blinks
umber, then does not turn off but stays lit
umber.
Make sure the modem and router are turned on and connected properly.
The NetAV Check page does not appear.
Check the “Cannot connect to the Internet” (
Station.”
The NetAV Check page failed.
• Check the settings in accordance with the information displayed on the
NetAV Check page, then perform the test again.
NetAV LED stays green.
Another device is connected by NetAV.
Problem
Causes and remedies
The setup screen disappears soon after
configuring settings.
• If you change the IP address of [Internet Connection] while using a
wired LAN to configure the base station settings, the setup screen will
no longer be able to be accessed. If this happens, select [Base Station
Settings] from the [Base Station Selection] window and reset the
setting.
• The base station is restarted automatically when you click [Exit Setup].
Perform the following operation to check the base station settings
again.
When connected to the base station via a wireless
connection:
Try establishing a wireless connection to the base station again and then
click [Base Station Settings] from the [Base Station Selection] screen.
When connected to the base station via a wired LAN:
Switch the base station to setup mode, then click [Base Station
Settings] from the [Base Station Selection] screen.
• For questions about Internet connections, contact your Internet Service Provider (ISP) or cable TV company.
• LocationFree FAQ pages http://www.sony.com/locationfree/faq/