Sony VGP-XL1B2 - Manual (Page 16)

10 VGP-XL1B User Guide
Installing VGP-XL1B
The installation process consists of the following steps.
Step 1: Before You Begin
Before connecting your VGP-XL1B CD/DVD Changer/Recorder to
the host computer, consider the environment in which it will be
placed. Listed below are some general guidelines.
• Do not set up the VGP-XL1B in the following locations:
- in direct sunlight
- near a magnet or a item that generates a magnetic field
- areas with high heat, such as near a heater
- areas with excessive heat, dust, and humidity
- areas with poor ventilation
Please observe the following items to avoid damage.
• Always turn off the power before the Changer/Recorder is
moved. Damage may be caused to the changer if the device is
transferred or moved with the power on.
• Do not move the Changer/Recorder if there are discs inside the
carousel. Remove all discs from the changer before moving.
• Do not tip or hit this device. Even a slight vibration or small
impact may cause a disc to come loose or cause damage to the
discs or carousel.
• Do not set up where it is not physically secure.
• Do not obstruct the ventilation holes or place heavy objects on
top of the device.
• If the host computer and the Changer/Recorder are placed in
an enclosed cabinet, make sure there is sufficient airflow.
Step 1 Review the section titled Before You Begin .
Step 2 Install the Changer Software CD on the host computer.
Step 3 Connect the VGP-XL1B to the host computer.
Kansas2.book Page 10 Wednesday, February 1, 2006 8:00 AM