Sony MZ-R500 - Manual (Page 29)

29
-GB
Labeling a track during
playback
1
Insert a disc and play the track you
want to label.
2
Press ENTER, press
>MENU. repeatedly until
“EDIT” flashes in the display, and
then press ENTER again.
“
” and “Name” flash in the
display.
3
Press ENTER.
The track is ready to be labeled.
4
Follow steps 3 to 5 of “Labeling a
disc during stop”.
Labeling a track or a disc
during recording
1
While recording, press ENTER, press
>MENU. repeatedly until
“EDIT” flashes in the display, and
then press ENTER again.
“
” and “Name” flash in the
display.
2
To label a track, press ENTER again.
To label a disc, press
>MENU. repeatedly until
“
” and “Name” flash in the
display.
The track or disc is ready to be
labeled.
3
Follow steps 3 to 5 of “Labeling a
disc during stop”.
To cancel labeling, press x.
Notes
• When the recording is stopped while labeling
a track or a disc during recording, or when the
recording moves on to the next track while
labeling a track, the input at that point is
entered automatically.
• “LP:” has automatically been added at the
beginning of track names for tracks recorded
in LP2 or LP4.
Relabeling recordings
Follow the steps corresponding to the
labeling method until the disc or track is
ready to be labeled. Enter a new character
over the one you want to change, then
press ENTER.
Notes
• You cannot relabel premastered MDs or label
MDs that have not been recorded.
• The recorder is able to display, but cannot
label using Japanese “Katakana” characters.
• The recorder cannot rewrite a disc or track
name of more than 200 letters that was created
by another device.