Sony MZ-R500 - Manual (Page 17)

17
-GB
2
Press >MENU. repeatedly to
select the desired recording mode.
3
Press ENTER.
4
Press N while pressing REC.
The recording starts.
5
Play the source sound.
To stop recording, press x.
The settings of the recording mode
remains when you record the next time.
z
• Audio components that support the LP2 or
LP4 modes are indicated by the or
logo marks.
• Once you set, the recorder keeps its recording
mode when you record the next time.
Notes
• You cannot change the recording mode while
recording.
• It is recommended that you use the AC power
adaptor for long recordings.
• If you try to play an MD recorded in LP2 or
LP4 on a player/recorder that is not support
these modes, playback will not start and “LP:”
will appear on the display.
• Sound recorded through digital (optical) input
can be monitored in stereo through
headphones/earphones, etc.
• When you record in LP4 mode, momentary
noise may be produced on very rare occasions
with certain sound sources. This is because of
the special digital audio compression
technology that enables a recording time 4
times longer than normal. If noise is produced,
it is recommended that you record in normal
stereo or LP2 mode to obtain better sound
quality.
To start/stop recording
in sync with the source
player
(Synchro-recording)
You can easily make digital recordings of
a digital source on an MD.
Before synchro-recording, make
connections to the digital source with a
digital cable, and insert a recordable MD.
1
Press ENTER while the recorder is
stopped.
Recording
mode
1)
1) For better sound quality, record in normal
stereo or LP2 mode.
Display Recording
time
3)
3) When using an 80-minute recordable MD.
Stereo Stereo 80 min.
LP2 stereo LP2 160 min.
LP4 stereo LP4 320 min.
Monaural 2)
2) If you record a stereo source in monaural, the
sounds from left and right will be mixed.
Mono 160 min.
CD players,
etc.
N
REC
>MENU.
ENTER
continued