Sony PEG-UX40 - Manual (Page 124)

124
Performing the IR HotSync
®
operation
Exchanging and updating files/data using the HotSync
®
operation (Other HotSync
®
operations)
2
Click (HotSync) in the Windows task tray (Notification
area) at the bottom right of the computer window once again,
and select [Setup] from the shortcut menu.
The Setup window is displayed.
3
Click [Local] tab.
4
Adjust the following settings as needed.
• Serial port : Specifies a virtual port for an infrared port. If you are not
sure of the connection port, refer to the Infrared Monitor in the
Control Panel .
• Speed : Determines the speed at which files/data are transferred. Try
the As Fast As Possible rate first, and adjust downward if you have
any problems.
5
Tap [OK].
The IR HotSync
®
operation is enabled.
Note
When performing a local HotSync
®
operation with a USB cable, you need to restore the
local HotSync settings.
b
For details, refer to “To restore the local HotSync settings” on page 125.
Continued on next page
• • • • • • • • • • • • • • • • • • •