Sony DCR-PC105 - Manual (Page 62)

62
The POWER switch should be set to .
Operate by touching the panel.
(1) Press FN, then select PAGE2.
(2) Press DIG EFFT. The screen to select a digital effect is displayed.
(3) Press the desired mode. When you select STILL or LUMI., the still image is
stored in memory.
(4) Press – (to decrease the effect)/+ (to increase the effect) to adjust the effect.
Items to adjust
SLOW SHTR Shutter speed. The larger the shutter speed number, the slower the shutter speed.
OLD MOVIE No items need to be adjusted.
STILL The degree of the still image you want to superimpose on the moving picture
FLASH The interval of flash motion
LUMI. The brightness of the area in the still image which is to be swapped with a moving
picture
TRAIL The vanishing time of the incidental image
(5) Press OK to return to PAGE2.
Using special effects – Digital effect
2 4
DIG
EFFT DIG EFFT
STILL
SLOW
SHTR
OLD
MOVIE
OFF OK
LUMI. FLASH TRAIL LUMI.
OK OFF
DIG EFFT
The bar appears when setting following
digital effect modes: STILL, FLASH,
LUMI., TRAIL.