Avaya P332G-ML - Manual (Page 59)

Avaya P332G-ML User’s Guide 45
Chapter 9
Default Settings of the P330
This section describes the procedures for the first-time configuration of the Avaya
P330. The factory defaults are set out in detail in the tables included in this chapter.
Configuring the Switch
The Avaya P330 may be configured using the text-based Command Line Interface
(CLI), the built-in Avaya P330 Device Manager (Embedded Web) or Avaya Multi-
Service Network Manager™.
For instructions on the text-based CLI, see the Avaya P330 Reference Guide.
For instructions on installation of the graphical user interfaces, see Embedded Web
Manager. For instructions on the use of the graphical user interfaces, refer to the
Device Manager User’s Guide on the Documentation and Utilities CD.
Avaya P330 Default Settings
The default settings for the Avaya P330 switch and its ports are determined by the
Avaya P330 software. These default settings are subject to change in newer versions
of the Avaya P330 software. See the Release Notes for the most up-to-date settings.
Table 9.1 Default Switch Settings
Function Default Setting
IP address 149.49.32.134
Subnet Mask 255.255.255.0
Default gateway 0.0.0.0
Management VLAN ID 1
Spanning tree Enabled
Bridge priority for Spanning Tree 32768
Keep alive frame transmission Enabled
Network time acquisition Enabled, Time
protocol
Time server IP address 0.0.0.0