Avaya P332G-ML - Manual (Page 43)

Chapter 6 Avaya P332G-ML Front and Rear Panels
Avaya P332G-ML User’s Guide 29
Note: All LEDs are lit during reset.
FC Flow Control
OFF – No flow control.
ON – One of the three possible flow control
modes is enabled.
Note: FC LED for Gigabit Ethernet ports
reflect the last negotiated mode when
autonegotiation is enabled and the link is
down.
Hspd High Speed Always ON – 1000 Mpbs mode only
LAG
Link Aggregation
Group (Trunking)
OFF – No LAG defined for this port
ON – Port belongs to a LAG
Table 6.2 Avaya P332G-ML <- -> Select buttons
Description Function
Left/Right Individual – select LED function (see table above)
Reset module Press both right and left buttons together for approximately 2
seconds. All LEDs on module light up until buttons are
released.
Reset stack Press both Right and Left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
Table 6.1 Avaya P332G-ML LED Descriptions (Continued)
LED Name Description LED Status