You can change the Rapid Wake settings in VAIO Control Center.
Rapid Wake is enabled by default. With this function, your VAIO enters Sleep
mode after your working data is saved on the built-in storage device.

1. Start VAIO Control Center and select Hardware. (See

Searching/Starting

Apps, Settings, or Files

to start VAIO Control Center.)

2. Enable/disable the setting in Rapid Wake.

Note

With Rapid Wake disabled:

Your working data is not saved on the built-in storage device when your VAIO

computer enters Sleep mode. Therefore, if the computer is turned off during Sleep

mode because, for example, the battery pack runs out of power or the computer

is disconnected from an AC power source, the working data will be lost. To avoid

data loss, be sure to save the data before the computer enters Sleep mode.
If your VAIO computer is equipped with the power indicator, it blinks slowly in

orange during Sleep mode. When the battery pack runs out of power during Sleep

mode, the charge indicator light blinks. If the computer is equipped with the

power indicator, it blinks along with the charge indicator.

Go to Page Top