Indicator lights rapid advance, Warning – Alliance Laundry Systems FRONTLOAD WASHERS FLW1526C User Manual

Page 24

Operation

802734

Indicator Lights

IN USE
This light will remain on while washer is in use.
DOOR LOCKED
This light will come on after the PUSH-TO-START

button has been pressed and the washer door has

locked. It will remain on until the wash cycle has

ended.
FINAL SPIN AND TUMBLE
This light will come on at the start of the final spin and

remain on until the wash cycle has ended.
CLOSE DOOR
This light will come on if door is not closed tightly.

Firmly push door until light goes out.

IMPORTANT: If washer fails to operate properly

after installation, make sure electrical service and

water supply faucets are turned on. Are all the

controls properly set? Have a qualified service

person refer to the wiring diagram (located inside

of cabinet) and check for broken, loose or incorrect

wiring.

NOTE: Once a cycle has started, the door can only

be opened by first unplugging the power cord and

waiting one minute.

The washer will stop (pause) shortly before the first

spin and final spin.

Rapid Advance

The Rapid Advance feature allows the owner to

quickly advance through an active cycle to a specific

cycle step.
To enter Rapid Advance, open the service door long

enough for the IN USE light to turn on and close the

door. Refer to Figure 32.

NOTE: If service door remains open, rapid

advance cycles can be used for a free vend.

Press the PUSH-TO-START button to start the cycle.

Press PUSH-TO-START button again to advance

through each cycle step. Refer to Table 1 for cycle

steps.

To reduce the risk of bodily injury, do not

remove laundry from washer until all

lights are out, and all moving parts have

stopped.

W092

WARNING

Cycle Steps

Wash Fill/Agitate cycle step
Wash Distribute cycle step
Wash Pulse Spin cycle step
Rinse Fill/Agitate cycle step
Rinse Distribute cycle step
Rinse Pulse Spin cycle step
Extra Rinse Fill/Agitate cycle step (If extra rinse is
enabled)
Extra Rinse Distribute cycle step (If extra rinse is enabled)
Extra Rinse Pulse Spin cycle step (If extra rinse is enabled)
Final Fill/Agitate cycle step
Final Distribute cycle step
Final Pulse Spin cycle step

Final High Spin cycle step (Final Spin light on)
Breakaway cycle step (Final Spin light on)
End of cycle (door will remain locked for about 1 minute)

Table 1