Auralex SonoFlat System SFS-184 - Manual (Page 2)

Recommended Additional Installation Materials
• Caulk-gun (for Tubetak Pro) • Tape measure
• Carpenters Level • Small ladder (depending on ceiling height)
SonoFlat SFS-184 General Information
Q’Fusor Installation Guide
Optional Additional Installation Materials
• Foamtak Spray Adhesive* • T-Pins
* This system includes Tubetak Pro Adhesive, which is safe to use on all included products. You may wish to use Auralex’s Foamtak Spray Adhesive
for quicker drying times. Foamtak is available through all Auralex authorized dealers. Do NOT use Foamtak to install Q’Fusors.
SonoColumn Placement Options
➋ ➊ ➍ ➌
Flush in corner At 45° to corner Side-by-side in corner On wall w/ Collars
➊
Apply Tubetak Pro to the back of the
Q’Fusor, as pictured.
➋
Carefully press Q’Fusor into the face of a
SonoFlat Panel or directly to the surface of a
wall or ceiling.
TIP
If you plan on painting the Q’Fusor, make sure to do so
before applying it to the wall or ceiling.
CAUTION
Use only lwater-based paints on the Q’Fusor. Oil-based
paints will cause severe deterioration of the product.