Auralex Hemisphere - Manual

Hemisphere ™ Installation Guide
1-800-959-3343 / 317-842-2600
9955 Westpoint Drive, Suite 101, Indianapolis IN USA 46256
1151-314.Barrel Diffusor User Guide.indd (06/30/2014 - 1:27 PM)
Pop Rivet
Top “L” Clip
Fastener by others
Fastener
(by others)
“L” Clip
“L” Clip
“Z” Bar
Tek Screw
Side & Bottom “L” Clip
Typical Side View
Horizontal - Rear View
Vertical - Rear View
Vertical - Rear View
Horizontal - Rear View
Vertical - Side View
Horizontal - Side View
“Z” Bar
Wall
L-Clips
L-Clips L-Clips
L-Clips 1/2” 1/2”
1/2” 1/2”
EQ EQ
EQ EQ
EQ EQ EQ EQ
EQ EQ
Z Bar
Wall
EQ
EQ
1/2”
1/2” 1/2”
1/2”
L-Clips
L-Clips
L-Clips
L-Clips
Bottom
Bottom
Bottom
Bottom
Wall
Z Bar
L-Clip
L-Clip
Review the drawings and details before beginning assembly. Also, note if your installation calls for
vertically or horizontally hung diffusors -- see drawings below.
Top L-Clip Attachment - see drawings for clip locations
1. Align top L-Clips so the 3/4” leg is flush with the edge of the diffusor.
2. Using the L-Clip as a template, mark and drill (2) 1/8” holes from the top down.
3. Insert pop-rivets from the top down and rivet the L-Clip to the diffusor.
4. Note: Top clips receive Z-Bar mounting.
Mounting Diffusors to the Wall
1. Attach Z-Bars for top clips to the wall using appropriate fasteners (fasteners are not included)
making sure they are aligned with the top clips on the diffusor. The top of each Z-Bar should be
1/8” below the desired diffusor height. Be sure to allow 1” minimum clearance above the top of
each Z-Bar for clip attachment.
2. Attach bottom and side L Clips (see drawings for clip locations) to the wall using appropriate
fasteners (fasteners not included). L Clips should be 1/8” inside the exterior edge of the diffusor.
3. Install the diffusor by dropping the top clips on to the Z-Bar so they are fully engaged.
4. Be sure the exterior edge of the diffusor overlaps and hides the bottom and side L Clips. Attach
the diffusor to the side and bottom L Clips with #8 x 3/4” Tek Screw.
Small Diffusors: 1.5x1.5, 2x2, 2x3, 2x4, 3x3 and 4x4
Parts List:
3 - 6”, L-Clips
2 - 6”, Z-Bars
4 - Pop Rivets
1 - Tek Screw
Large Diffusors: 2x6, 6x2, 3x5, 5x3, 4x5, 5x4, 3x6, 6x3, 4x6, 6x4, 4x8 and 8x4
Horizontal Parts List:
5 - 6”, L-Clips
3 - 6”, Z-Bars
6 - Pop Rivets
2 - Tek Screws
Vertical Parts List:
5 - 6”, L-Clips
2 - 6”, Z-Bars
4 - Pop Rivets
3 - Tek Screws