Sony ST-SB920 - Manual (Page 11)

11 GB
Advanced Tuner Operations
Storing stations automatically (Auto
Memory)
This section explains how to prestore all FM stations in
your broadcasting area in one operation.
1
Press MENU.
2
Turn TUNING/SELECT until “AUTO-MEM”
appears and then press ENTER.
3
Turn TUNING/SELECT until “Y/N YES”
appears and then press ENTER.
The tuner scans for FM stations starting with the
lowest frequency. When a station is detected, it is
stored automatically into the tuner’s memory.
Stored stations are assigned a two-character code
starting with A1.
To cancel storing the stations
Press ENTER while the tuner is scanning for the
stations in step 3.
Naming the Preset Stations
You can assign a name up to 5 characters long to each
preset station. When the station is tuned in, the station
name will appear instead of the frequency.
TUNING / SELECT
SHIFT
MEMORY DISPLAY MENU
ENTER
MEMORY DISPLAY
FM MODE BAND
SHIFT DIRECT 0 9 8 7 6 5 4 3 2 1
MENU TUNE MODE
RETURN
TUNING / SELECT
ENTER
1
Press MENU.
2
Turn TUNING/SELECT until “CHAR” appears
and then press ENTER.
3
Turn TUNING/SELECT to select a character.
4
When the character you want appears, press
MEMORY to move the cursor into position for the
next character.
If you make a mistake
Press MEMORY repeatedly until the character you
want to change flashes (every time you press
MEMORY, the next character flashes). Then turn
TUNING/SELECT to select a new character.
Numeric
buttons
5 Repeat steps 3 and 4 until the station name you
want appears in the display.
6
Press ENTER.
The station name is memorized and the station’s
preset code flashes.
7
Press ENTER again.
Note
The display returns to normal display mode if you stop
assigning names for more than 8 seconds. If this happens,
start again from the beginning.
z
To see the frequency of the displayed station name
Press DISPLAY repeatedly.
z
You can label the station before presetting it
1 Tune in the station.
2 Do steps 1 to 5 above.
3 Press ENTER.
4 Press SHIFT and a numeric button to assign a preset
code to the station and then press ENTER.