Asus A7V400-MX - Manual (Page 42)

2-10 Chapter 2: BIOS information
A note about passwords
The BIOS Setup program allows you to specify passwords in the Main menu.
The passwords control access to the BIOS during system startup. Passwords
are not case sensitive, meaning, passwords typed in either uppercase or
lowercase letters are accepted. The BIOS Setup program allows you to specify
two different passwords: a Supervisor password and a User password. If you
did not set a Supervisor password, anyone can access the BIOS Setup
program. If you did, the Supervisor password is required to enter the BIOS
Setup program and to gain full access to the configuration fields.
Forgot the password?
If you forget your password, you can clear it by erasing the CMOS Real Time
Clock (RTC) RAM. The RAM data containing the password information is
powered by the onboard button cell battery. If you need to erase the CMOS
RAM, unplug the all the power cables and remove the button cell battery. Re-
install the battery after about 2 seconds, then power up the system. Refer to
section “1.11 Switch and Jumpers - Clear RTC RAM” on how to erase CMOS
RTC RAM.
Security Option [Setup]
This field requires users to enter the password before entering the BIOS setup or
the system. Select [Setup] to require the password before entering the BIOS
Setup. Select [System] to require the password before entering the system.
Configuration options: [Setup] [System]
Installed Memory [XXX MB]
This field automatically displays the amount of conventional memory detected by
the system during the boot process.
Halt On [All Errors]
This field sets the system to halt on errors according to the system functions
specified in each option. Configuration options: [All Errors] [No Errors]
[All, But Keyboard] [All, But Diskette] [All, But Disk/Key]