Addonics Technologies 1:1 HDD DUPLICATOR PRO-S HDUSI325AES - Manual (Page 12)

All data will be
lost,Erase? No
Press
ENT
again and the LCD will prompt you to confirm the erase operation.
Test IDE 0/1
OK
LCD Test Start Button Test ? SDRAM Test:
8192Kbytes OK
FlashTest: OK Test finished
Once the system diagnostics have been completed the "Test finished" message will appear on the
LCD.
Press
ENT
and the system will begin the tests as shown below.
H/W Diagnostic
Press
ENT
to enter the following screen. This function is used to check that the system is
operating normally.
11-06.Adv Setup
H/W Diagnostic
Press
ENT
again to enter the following screen. The LCD will cycle through the test categories as
they are performed. The LCD display is tested first, the control panel is tested next (requires
manual operation), then followed by the system's internal diagnostics, hardware connection test
then the RAM and SD Flash test. All test results are shown on the LCD. This is a simple way to
verify that the system is operating normally.
Quick Erase HDD
This function is used to quickly erase all data on the HDD . Please backup any important data
before using this function.
10-05.Adv Setup
Quick Erase HDD
Quick Erase HDD
ALL/Target CH:*
Press
ENT
to enter the following screen. Use the Up and Down buttons to select the HDD to
erase.
www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/