Karcher KMR 1250 Lpg - Manual (Page 39)

KMR 1250 LPG
User Instructions
English
39
!
Safety information applicable to maintenance tasks
Before you begin any maintenance tasks, please read the enclosed leaflet
Safety Information No. 5.956-250.
!
Caution! Make sure engine cannot be started unintentionally.
In order to prevent the engine from being started unintentionally, proceed as
follows after you have parked the sweeper.
n Pull out the ignition key.
n
Open the unit cover.
n
First of all disconnect the cable from the negative terminal (–), then dis-
connect the positive terminal (+).
Note:
When reconnecting the battery, proceed in reverse order – connect the
positive terminal (+) first of all, then the negative terminal (–).
The necessary maintenance tasks or daily inspections can be carried out with
the bonnet raised.
!
Injury hazard!
Do not open the bonnet until the motor has been switched off.
!
Burns hazard!
Take care not to touch the exhaust when you open the bonnet.
!
Injury hazard!
ç
If you need to work under the waste container while it is in the raised
position, you must first of all secure the container to prevent it from drop-
ping down unintentionally:
Maintenance tasks Checking tyre pressures
n
Park the sweeper on a level surface.
n
Check the air pressure in each tyre and correct it where necessary.
Air pressure for front and rear tyres = 6 bar.
Checking the oil level
n
Park the sweeper on a level surface.
ç Pull out the dipstick.
n Wipe the dipstick clean and re-insert it in the filler hole.
n
Pull out the dipstick again and check the result.
The oil level should be between the MIN and MAX marks.
If the oil level is below MIN – top up with oil.
If the oil level is above MAX – drain off the surplus.
n
Insert the dipstick back into the filler hole.
Filling up with oil
n
Pour engine oil type SAE 15 W 40 into the hole for the dipstick.