Haltech Platinum Sprint RE (HT050900) - Manual (Page 30)

PLATINUM SPRINT RE
Quick Start Guide
Congratulations on purchasing a Haltech Engine Management System.
This fully programmable product opens the door to virtually limitless performance
modification and tuning of your vehicle. Programmable systems allow you to extract
all the performance from your engine by delivering precisely the required amount
of fuel and ignition timing that your engine requires for maximum output under all
operating conditions.
This quick start guide will walk you through installation of a Haltech ECU into a
vehicle. This guide is accompanied by the full service manual located on the
software CD provided with the ECU that you or your tuner will need to refer to
before completing your installation and configuration. The Manual can also be
downloaded from the Haltech website
www.haltech.com
Installation
Air Temperature Sensor
The sensor should be mounted to provide the best representation of the actual
temperature of the air entering the combustion chamber, i.e. after any turbo or
supercharger, and intercooler, the optimum position being the intake pipe before the
throttle. The sensor needs to be in the moving air stream to give fast response times
and reduce heat soak effects.
The air temp sensor plug is labeled with the letters A and B and should be wired
with the signal wire (Grey) to pin B and signal ground wire (Black/White) to pin A
Figure 1– Air Temperature Sensor and Terminations