Haltech Platinum Sprint RE (HT050900) - Manual (Page 21)

2 nd Generation RX7 (FC3S) / Turbo II
Wiring
The wiring for this type of trigger system is as follows:
Figure 12- 2 nd Generation CAS and timing marks locations
RX8 (SE3P)
Fuel Setup
Wiring
All injectors share a common +12V supply voltage.
The ECU injector output completes the circuit to ground when fuel delivery is required.
When wiring for sequential fuel injection, fuel injectors should be wired as follows:
Settings
*Please refer to the Fuel Setup in the user manual for information regarding fuel system
settings
Trigger "+" 1 *Yellow Red Wire
Home "+" 2 **Yellow Green Wire
Trigger "-" 17 *Green White Wire
Home "-" 18 **Green White/Black Wire
* Denotes core colour inside Grey 4 core shielded cable
* *Denotes core colour inside Grey / Black 4 core shielded cable
2nd Generation RX7 (FC3S) / Turbo II Crank Angle Sensor Wiring
Trigger / Home
Input
Haltech ECU Pin
Number
Wire Colour
Crank Angle Sensor
Connection
Injector # 1 16 Blue Rotor # 1 - Primary
Injector # 2 15 Blue / Black Rotor # 2 - Primary
Injector # 3 14 Blue / Brown Rotor # 1 - Secondary
Injector # 4 13 Blue / Red Rotor # 2 - Secondary
RX8 Fuel Injector Wiring
Injector Output
Haltech ECU Pin
Number
Haltech
Wire Colour
Engine Connection