elektraLite UFO 8 - Manual (Page 6)

11. Manual.
The UFO 8 can be manually controlled without the need for a dmx controller.
Using the Menu button in the root menu go to Manual.
Press Enter then using the
↑ or ↓ buttons choose the channel that has to be controlled.
Press Enter and then using the
↑ or ↓ buttons set the DMX value for that channel.
Press Enter again after the correct DMX value has been reached in order to save that value.
This will need repeated for all the channels that manual control is required.
12. Restore.
The UFO 8 motors can all be reset and the UFO 8 can also be restored to factory default settings.
Using the Menu button in the root menu go to Restore.
Press Enter then using the
↑ or ↓ buttons choose between Motor or Factory.
Press Enter to save desired Choice.
There will be a delay of up to 5 seconds before the reset or Factory default is started.
13. DMX Channel Assignments.
1 0 to 540 ⁰ Pan Movement 0-250
2 0 to 280 ⁰ Tilt Movement 0-255
3 0 to 540 rotational movement 0-255
4 Speed channel (default is to keep this at 0) 0-255
5 Strobe (from slow [0] to fast [255]) 0-255
6 Brightness/dimming 0-010
7 No effect/function 000-015
Automatic programs 011-127
Sound programs 128-245
Reset (If between 246-255 then resets will constantly be repeated!!) 246-255