elektraLite MM 150 - Manual (Page 8)

-
７ -
Display Panel
The Display Panel offers several features: for example, you can simply set the starting address, run the
pre-programmed “shows” or reset the fixtures motors.
The main menu is accessed by pressing the Mode/esc-button until the display starts flashing. Browse through
the menu by pressing the Up-button or Down-button. Press the Enter-button in order to select the desired
menu. You can change the selection by pressing the Up-button or Down-button. Confirm every selection by
pressing the Enter-button. You can leave every mode by pressing the Mode/esc-button . The functions
provided are described in the following sections.
Default settings shaded.
Main functions
Main
menu
Sub
menu
Extension Display Function
VALU A001~A511 (AXXX) DMX address setting
ADDR
SLAV ON/OFF (SLAV) Slave setting
ALON (AU-A)
Automatic Program Run
in Stand Alone
AUTO
MAST (AU-M)
Automatic Program Run
as Master
ALON (SO-A)
Sound-controlled Program
Run in Stand Alone
RUN
SOUN
MAST (SO-M)
Sound-controlled Program
Run as Master
VALU
D-XX D–00
(DXXX) Display the DMX 512 value
of each channel
RDIS ON/OFF Reverse display
0 MODE
DISP
CLDI ON/OFF Shut off LED display
RPAN ON/OFF Pan Reverse
RTIL ON/OFF Tilt Reverse
REST Reset
LODA ON/OFF Restore factory settings
1 SET
VER V-1.0~V-9.9 Software version
LADJ ON/OFF Lamp adjustment
2 ADJU
TEST T–01 ~ T–30 Test function of each channel
MATI 0000~9999 (hours) Fixture running time
LATI 0000~9999 (hours) Lamp running time
CLMT ON/OFF Clear fixture time
3 TIME
CLLT ON/OFF Clear lamp time
STEP S–01 ~ S–48 Steps of Program Run
C–01 ~ C–30
01XX (00~FFH)
30XX (00~FFH) Edit the channels of each
scene
TIME (sec.) T – – X (1~9) Time for each scene
4 EDIT
SC01
~
SC48
CNIN ON/OFF Edit program via controller