elektraLite MM 150 - Manual (Page 12)

-
１１ -
With this function you can test each channel on its (correct) function.
1. Select
“TEST” by pressing [UP] button.
2. Press [ENTER], the display shows “T-XX”, “X” stands for the channel number.
3. The current channel will be tested.
4. Select the desired channel by pressing [UP] or [DOWN] button.
5. Press
[ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Main menu 4
1. Press [MODE/ESC] to enter the main menu (display flashing).
2. Press [UP] or [DOWN] button to select “TIME”. Press [ENTER].
- Fixture running time
With this function you can display the running time of the fixture.
1. Select
“MATI” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “XXXX”, “X“ stands for the number of hours.
3. Press
[ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Lamp running time
With this function you can display the running time of the lamp.
1. Select
“LATI” by pressing [UP] button.
2. Press [ENTER], the display shows “XXXX”, “X“ stands for the number of hours.
3. Press
[MODE/ESC] to return to the main menu.
- Clear fixture time
With this function you can clear the running time of the fixture.
1. Select
“CLMT” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press
[UP] to select “ON” if you wish to enable this function
or press [DOWN] button to “OFF” if you don’t.
4. Press [ENTER] to confirm or Press [MODE/ESC] to return to
the main menu.
- Clear lamp time
With this function you can clear the running time of the lamp.
Please clear the lamp time every time you replace the lamp.
1. Select
“CLLT” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press
[UP] to select “ON” if you wish to enable this function
or press [DOWN] button to “OFF” if you don’t.
4. Press [ENTER] to confirm or Press [MODE/ESC] to return to
the main menu.
- Main menu 5